Conserving Battery Power - Fujitsu Point 1600 User Manual

2. Slide the battery latch on the battery pack currently installed in the pen tablet to
the open position as shown in Figure 2-2.
3. Slide the battery pack out of the pen tablet.
You can now install a charged battery pack in the pen tablet and charge the battery
pack that you removed in an external battery charger if one is available. See the
instructions that came with your external battery charger for details.
4. To install a battery pack in the pen tablet, slide the latch on the battery pack to the
open position.
5. Slide the battery pack into the pen tablet until it fits snugly. Slide the latch to the
closed position to latch the battery pack in place.
You can now start or resume the system and use the pen tablet.

Conserving Battery Power

A fully charged battery pack can power the Point 1600 pen tablet for about 4 hours
under typical use (with power management). Your results may vary depending on
how the pen tablet is configured. You can extend the life of your battery pack by
conserving battery power.
Figure 2-2 Removing the Battery Pack
Battery Pack
Slide battery pack
out to remove.
Battery Latch
Conserving Battery Power
Slide latch to open.
2
2-13