Ensuring Pen Accuracy; Using Hotpads - Fujitsu Point 1600 User Manual

Ensuring Pen Accuracy

The Point 1600 pen tablet comes from the factory already calibrated so that the cursor
location matches the pen tip location. If the cursor is not displayed directly under the
pen tip when you touch the screen, then you should calibrate the pen tablet. For more
information, see "Calibrating the Pen" on page 3-4.

Using Hotpads

The hotpads are controls along the lower edge of the Point 1600 screen that let you use
functions and make adjustments to the system. You use the hotpads by tapping them
with the pen. The following figure shows the name of each hotpad. Table 2-2 shows
the function performed when you tap each hotpad.
Display Select
Speaker Volume
Speaker
Volume
Display Select
Right Mouse
button
Contrast Down
Contrast Up
Brightness
2-10 Using the Point 1600 Pen Tablet
Contrast Down
Right Mouse Button
Table 2-2 Hotpads
Tap this hotpad to change the speaker volume to
the low, medium, high, or off setting. (Note that the
sound level may also be controlled by settings in
your application or operating system software.)
Tap this hotpad to select an external monitor, the
pen tablet display screen, or both as the active
display.
Tap this hotpad once to perform a right mouse
button click with your next pen tap.
Tap these hotpads (or press and hold with the pen
tip) to adjust the display screen contrast up or
down.
Tap this hotpad to change the display brightness
setting. The brightness can be set to one of 2
levels (high or low).
Contrast Up
Brightness
2
2