Tips For Conserving Battery Power; Modem Connection - Fujitsu Stylistic Manual

• If a charged battery is not available, save
your work and close all running programs,
then shut down the system or Hibernate
(Save-to-Disk).
• Plug in an external DC power source.
2. Slide the battery release latch in the
direction indicated. (See Figure on page 24
for location) .
3. Pull the battery away from the system, as
shown in the illustration and remove the
battery from the Tablet PC.
If you are using an external battery charger,
refer to the instructions provided with the
battery charger.
To install the battery:
1. Orient the battery with the slides in the
empty battery tray. Slide the battery into the
tray and press it firmly until it is seated.
When it is properly seated, the battery
release latch should return to position and
lock the battery.
Figure 2-2 Removing the Battery
Once the battery is installed, you can resume
system operation or start and use your system
normally.
TIPS FOR CONSERVING BATTERY
POWER
You can extend the charge life of your battery
by conserving battery power. (Your results may
vary depending on your application and how
the system is configured.) Here are some
suggestions to help you conserve battery
power:
• Use an external power source such as the
AC adapter whenever the system is docked.
• Suspend system operation if you know that
you won't be using the system for a while.
U s i n g Yo u r S t y l i s t i c S T 4 1 1 0
• Shut down the system if you won't be using
the system for an extended period of time.
• Use power management (available on the
desktop) to help you conserve power
automatically.
• Battery life is dependent upon the operating
system, power settings, and applications in
use.
Operation of the Bridge Battery
When installed in the Tablet PC, the battery
provides power to some system components—
even when the system is in the Off state. When
the battery is removed, power is supplied to
these components by a "bridge" battery that is
built into the Tablet PC.
The bridge battery is not designed for long-
term operation. To maintain the bridge battery
properly, observe the following measures:
The bridge battery function is disabled
if Wake On LAN is enabled in the BIOS.
The system arrives with the bridge
battery in a discharged state. Be sure to
charge it sufficiently before relying upon
it to support the system in the event of
battery removal.
• To prevent draining the bridge battery,
always store the system with a charged
battery installed.
• If the bridge battery becomes drained, it
takes approximately 8 hours for it to be fully
recharged.
• The bridge battery charges when the AC
Adapter is connected and the system is in
On or Off states or Suspend mode. It
charges from the battery only when the
system is in the On state.

MODEM CONNECTION

The Stylistic ST4110 Fujitsu Tablet PC is
designed to accept a standard RJ-11
telephone plug. Connect the plug to the
modem jack located on the left-hand side of
the Tablet PC (See Figure 1-4 on page 6 for
location) . The telephone plug can be installed
whether or not the Tablet PC has power
applied.
25