NEC NVM-2000 Manual page 9

Issue 1-0
All manuals and user guides at all-guides.com
Installing an Expansion Drive
Secure the expansion drive in place with four screws. See Figure 8.
cut-away
view
Figure 8
Refer to Figure 9. Using the screws you previously removed, re-attach the hard drive/
floppy drive bucket assembly to the side of the expansion hard drive. If you disconnected
the green "chassis ground" wire, re-connect it. Tighten the screw to secure in place.
*
Note: For clarity, power wires and
ribbon cables are not shown.
Figure 9
Go to step 13.
Install the Drive
DT-expHD-10
)
DT-expHD-8
+
5