NEC NVM-2000 Manual page 11

14. Disconnect the ribbon cable from the master hard drive.
15. Plug the end connector of the ribbon cable into the expansion hard drive. See Figure 12.
Issue 1-0
All manuals and user guides at all-guides.com
Use Figure 3 as a reference for panel location. To re-attach the front panel to the cabinet,
simply push the spring clips into the holes of the cabinet until the clips snap and lock the
front panel in place.
Go to step 13.
Insert the connector on the ribbon cable so that the red stripe on the rib-
bon cable is closest to the power connector on the hard drive.
red stripe
Note: For clarity, floppy ribbon cable and
all power wires are not shown.
Figure 12
Installing an Expansion Drive
IMPORTANT
Install the Drive
DT-expHD-13
red stripe
7