NEC NVM-2000 Manual page 6

Installing an Expansion Drive
Install the Drive
8. Remove the cabinet cover as follows:
9. On many styles of desktop cabinets, the front panel would have been removed when you lifted
2
All manuals and user guides at all-guides.com
If the power switch on your cabinet is mounted on the rear of the cabinet (above the power
supply vent fan), slide the cover/front panel assembly 1 3/4 inches towards the front of the
cabinet, and lift up. See Figure 2.
If the power switch on your cabinet is mounted on the front panel, slide the cover 1/2 inch
towards the rear of the cabinet and lift up. See Figure 2.
Slide 1/2“, then lift.
1 - 3/4“
Power Switch
mounted at
rear of cabinet.
DT-expHD-2
Figure 2
off the cabinet cover. If your front panel is removed, go to step 9. If it is still attached:
Do not remove the front panel if it is secured to the cabinet with screws. Go to step 9.
If your front panel is secured to the cabinet with 5 metal spring clips:
Grab the notch located beneath the front panel (on the end where the logo is located)
and firmly pull the front panel away from the chassis. See Figure 3.
Figure 3
1/2“
Power Switch
mounted on
front panel.
Slide 1-3/4“, then lift.
Grab at notched
area and pull.
DT-expHD-3
Issue 1-0