NEC NVM-2000 Manual page 14

Installing an expansion drive

Hide thumbs Also See for NVM-2000:

Installing an Expansion Drive

Write the Hardware Settings for the New Drive to CMOS

You must write the settings for the new expansion (slave) drive to CMOS. The procedure you use

depends the type of motherboard already installed in your Voice Mail.

Determine the Proper Procedure for Writing to CMOS

To determine which procedure to use:

1. Turn on Voice Mail system power.

2. Carefully watch the screen on your monitor.

Procedure A: Write Expansion Drive Settings to CMOS

To write the hardware settings for the Expansion Drive to CMOS:

1. Wait for the MR BIOS main menu screen to appear.

2. Use the Arrow key to move to the option Fixed Disk.

3. Press <Enter>. The cursor moves to Type ﬁeld in the Fixed Disk (D:) column.

4. Press Shift + ? key to enter the correct values in all the Fixed Disk ﬁelds. At the bottom of

5. Press the Escape key twice to return to the MR BIOS main menu screen.

6. Press F10 to Record and Exit from the MR BIOS utility.

All manuals and user guides at all-guides.com

If you see 486BL CPU in the upper right-hand corner of the screen, immediately press the

Esc (Escape) key. Continue using Procedure A.

If you see the ENERGY/Star logo in the upper right-hand corner of the screen, immediately

press the Delete key. Continue using Procedure B.

Note: If you do not press the Escape or Delete key quickly enough, the NVM will try to

boot up. You will eventually see the NVM Main Menu. If this occurs:

Shut down the Voice Mail System (using the Shutdown command).

Turn system power off.

Repeat step 1 and step 2 (above).

Note: You should have completed the two steps in Determine the Proper Procedure for

Writing to CMOS (on page 10) before you continue with this procedure.

the screen, look for the message: Completed - Press Any key to Continue.

NVM will boot up.

Issue 1-0