NEC NVM-2000 Manual page 8

Installing an Expansion Drive
Install the Drive
4
All manuals and user guides at all-guides.com
Set the bucket assembly off to the side. Do not disconnect any wires or ribbon cables from
either the floppy drive or the hard drive.
Note: You may also see a screw securing a green (chassis ground) to the hard drive/floppy
drive bucket assembly (part C on Figure 6). Remove this screw to disconnect the
green wire.
*
Note: For clarity, power wires and
ribbon cables are not shown.
Figure 6
Slide the expansion hard drive into the top of the cage until the top holes of the U-brackets
line up with the slots in the sides of the cage. See Figure 7.
Figure 7
)
DT-expHD-8
+
Line up these top holes of u-brackets
with top slots on the sides of cage
DT-expHD-9
Issue 1-0