Telephone Lines; Mouse Or Keyboard; External Monitor; Theft Prevention Lock - Fujitsu 735Dx User Manual

S e c t i o n F o u r

TELEPHONE LINES

To attach a telephone line to the internal
modem open the rear panel connector cover or
with the cover closed slide the panel in the con-
nector cover slightly opened to reveal the RJ-11
jack.Plug one end of the telephone cable into
the telephone line outlet.Orient the telephone
cable with the release latch on the connector
up. Push it into the jack until it clicks and
latches. (See Figure 1-9 on page 8.)
C A U T I O N
The internal modem is not intended for
use with Digital PBX systems. Do not
connect the internal modem to a digital
PBX as it may cause serious damage to
the internal modem or your entire note-
book. Consult your PBX manufacturer's
documentation for details. Some hotels
have Digital PBX systems. Be sure to find
out BEFORE you connect your modem.
106
MOUSE, KEYBOARD OR KEYPAD
Make sure the connector on your device is
the correct PS/2 type. Align the arrow on the
connector to point to the bottom of your note-
book and push it in until the connector seats.
A mouse, keyboard or keypad may be installed
and automatically recognized by your notebook
without restarting or changing setups.
(See Figure 1-8 on page 7.)

EXTERNAL MONITOR

You may install an external monitor on the
external monitor port on the rear panel of your
notebook. Make sure that the wide side o f the
connector is up and attach it to the port by
pushing in until it is seated,then tighten the
hold-down screw on each end of the connector.
(See Figure 1-9 on page 8.)
C A U T I O N
Pressing F10 while holding down the Fn
key allows you to change your selection
of where to send your display video. Each
time you press the combination of keys
you will step to the next choice. The
choices, in order, are: built-in display panel
only, external monitor only, or both built-in
display panel and external monitor.

THEFT PREVENTION LOCK

A physical security system lock can be installed
on the right side of your notebook. (See Figure
1-8 on page 7 for the location of the lock slot.)
Simply insert the key end of your security
system in the slot, rotate 90 degrees and lock.
(See Figure 1-8 on page 7.)