Location Setup; Lifting - Patterson-Kelley P-K STORM ST-5000 Installation & Owner's Manual

2.4 Location Setup

Lifting

The STORM 2500-6000 can be lifted by two methods. Lifting lugs attached to the heat exchanger,
shown in figure below, can be used to lift the unit. A variety of rigging equipment may be required to
properly lift the unit using the lifting lugs.
NOTE: Do NOT allow any rigging equipment to interfere with unit components as this can
damage the unit
Revised: December 8, 2021
Released: December 8, 2021
 Patterson-Kelley 2021
All Rights Reserved.
TM
P-K Storm Gas Fired Boiler
Technical Service 1.877.728.5351
2691000273 P-K Storm ST2500-ST6000
Installation and Owners Manual Rev C.docx
Page 4