Operations; Nuro Control Panel; Nuro Touch Screen Interface; Factory Tests - Patterson-Kelley P-K STORM ST-5000 Installation & Owner's Manual

4 Operations

®
4.1 NURO Control Panel
Once the boiler has been installed in compliance with this
manual, it is necessary to open the front door of the boiler in
order to access the power (on/off) switch located on the NURO
control panel as shown below:

NURO Touch Screen Interface

Once the boiler is switched to the "ON" position, the P-K Storm boiler can be programmed and
operated with the NURO
protects the touch screen which can be opened by pinching the clasp and swinging open to the left.

Factory Tests

Safe lighting and other performance criteria were met with the gas manifold and control assembly
provided on this boiler when the boiler underwent factory tests specified in ANSI Z21.13/CSA 4.9, latest
edition. (See "Factory Firetest" label on the rear surface of the boiler).
Revised: December 8, 2021
Released: December 8, 2021
®
touch screen interface located on the front door. A clear plastic cover
 Patterson-Kelley 2021
All Rights Reserved.
TM
P-K Storm
Technical Service 1.877.728.5351
®
Do not use this boiler if any part
has been under water.
Immediately call a qualified
service technician to inspect the
boiler and to replace any part of
the control system and any gas
control which has been under
water. Failure to do so could
result in electrocution, injury, or
death.
If overheating occurs or the gas
supply fails to shut off, do not
turn off or disconnect the
electrical supply to the pump.
Instead, shut off the gas supply at
a location external to the boiler.
N
OTICE
The On/Off switch only interrupts
power to the NURO
system. In order to fully remove
power to the entire boiler, use
the external disconnect.
2691000273 P-K Storm ST2500-ST6000
Installation and Owners Manual Rev C.docx
Gas Fired Boiler
!
®
control
Page 60