Procedure - Yamaha F80B Owner's Manual

Store the outboard motor in a dry, well-
●
ventilated place, not in direct sunlight.
Drain the remaining gasoline from the
●
vapor separator. Gasoline left in the va-
por separator for a prolonged period of
time will break down and could cause
damage to the fuel line.
EMU28305

Procedure

EMU29956
Flushing with the flushing attachment
1. Wash the outboard motor body using
fresh water. NOTICE: Do not spray wa-
ter into the air intake.
information, see page 69.
2. Disconnect the fuel line from the motor or
shut off the fuel cock, if equipped.
3. Remove the top cowling and propeller.
4. Install the flushing attachment over the
cooling water inlet. NOTICE: Do not run
the engine without supplying it with
cooling water. Either the engine water
pump will be damaged or the engine
will be damaged from overheating. Be-
fore starting the engine, be sure to
supply water to the cooling water pas-
sages. Avoid running the outboard
motor at high speed while on the
flushing attachment, otherwise over-
heating could occur.
ZMU03659
For further
[ECM01840]
[ECM02000]
1. Flushing attachment
5. Cooling system flushing is essential to
prevent the cooling system from clogging
up with salt, sand, or dirt. In addition, fog-
ging/lubricating the engine is mandatory
to prevent excessive engine damage due
to rust. Perform the flushing and fogging
at the same time. WARNING! Do not
touch or remove electrical parts when
starting or during operation. Keep
hands, hair, and clothes away from
the flywheel and other rotating parts
while the engine is running.
TIP:
When using the flushing attachment, main-
●
tain adequate water pressure and a steady
water flow.
If the overheat alert device is activated, turn
●
the engine off, and consult your Yamaha
dealer.
6. Run the engine at a fast idle for a few
minutes in neutral position.
7. Just prior to turning off the engine, quickly
spray "Fogging Oil" alternately into the in-
take silencer or the fogging hole of the si-
lencer cover, if equipped. When properly
done, the engine will smoke excessively
and almost stall.
8. Drain the remained gasoline in the vapor
separator with a container. Loosen the
drain screw, and then remove the cap.
Maintenance
[EWM00091]
67