Checks After Engine Warm Up; Shifting; Stop Switches - Yamaha F80B Owner's Manual

essary. Consult your Yamaha dealer if
the cause for the low oil pressure alert
cannot be found.
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU36980

Stop switches

Turn the main switch to "
●
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
●
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
●
with the clip removed from the engine shut-
off switch.
EMU34561
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
[ECM01831]
", or press the
1. Neutral interlock trigger
2. Move the remote control lever / gear shift
lever firmly and crisply forward (for for-
ward gear) or backward (for reverse
gear) [about 35° (a detent can felt) for re-
mote control models]. Be sure to check
that the tilt lock lever is in the lock/down
position (if equipped) before operating in
reverse.
Operation
53