Canon MR-14EXl Instructions Manual page 61

Manual Flash Mode
• The flash output is displayed on the
lower right of the LCD panel. When
A
is displayed, the flash output
displayed is for flash tube A.
Press the < <J > or < C> > button to
select flash tube A or B, then
press the < + > or < - > button to
set the flash output.
~
First select the flash tube, then set the
flash output for that flash tube.
• The remaining steps are the same as
steps 6 and 7 on the preceding page.
M
M
fiBiI!)
A : B
~.D
After step 3 on the preceding page, following the steps below to set a
different flash output between flash tube A and
B.
Press the
<RATIO>
button and
select
IimiI!l
A :
B •
~
Each time you press the button, the
selection will change in the following loop:
~(OFF)-~1imiI!l A:
B
I
~IimiI!lA:B:C~
Press the <-> button and set the flash output to --. This disables the
selected flash tube from firing.
• The -- setting comes after the 1/64 setting. The flash tube whose flash
output is set to -- will not fire. Also, you cannot set -- for both flash tubes.
61