Canon MR-14EXl Instructions Manual page 39

Manual Flash Mode
Firi'ngBothFlashTtllbe~
$t
aD,ifferentOutput
I
• The flash output is displayed on the
lower right of the LCD panel. When
A
is displayed, the flash output
displayed is for flash tube A.
Press the <
<J
> or
< C>
> button to
select flash tube A or B, then
press the <
+
> or <- > button to
set the flash output.
~
First select the flash tube, then set the
flash output for that flash tube.
• The remaining steps are the same as
steps 6 and 7 on the preceding page.
M
M
IiJ.iDI!)
A : B
~tD
For step 3 on the preceding page, following the procedure below to set a
different flash output between flash tube
A
and
B
Press the <RATIO> button and
select
IiBml A : B •
~
Each time you press the button, the
selection will change in the following loop:
r--+(OFF)-~
IiBml A : B
I
~IiBmlA:B:C~
Firing Only One Flash Tube
Press the <-> button and set the flash output to --. This disables the
selected flash tube from firing.
• The -- setting comes after the 1/64 setting. The flash tube whose flash
output is set to -- will not fire. Also, you cannot set -- for both flash tubes.
39