Canon MR-14EXl Instructions Manual page 46

Using the Wireless Flash System
You can also set a flash ratio for flash tubes A and 8 and set flash exposure
compensation for slave C. After step 1 on the preceding page, follow the
procedure below.
ETTL
--
1
Imm!l
A : B C
+0
:~D
8:1·
~.
2:1·1:1 ·1:2 ·1:4 ·1:8 at:
ETTL
--
1
Imm!l
A : B C
+
I
1/3
:~D8:1.~.
2:1·1:1·1:2 .1:4.1:8at:
Press the <
<J
> or <
C>
> button to
set a flash ratio for flash tubes A
and B.
• To set the flash ratio for flash tubes A
and 8, see page 27.
• The sample diagram on the left
shows the left: right flash ratio set to
4:1.
• When
emml
is displayed, you can
change the flash ratio anytime.
Press the <
+
> or <- > button to
set slave C's flash exposure
compensation amount.
• The amount can be set up to ±3
stops in 1/3- or 1/2-stop increments.
• The remaining steps are the same as
steps 2 and 4 on page 45.
46