External Power Sources - Canon MR-14EXl Instructions Manual

External Power Sources
~~1
Macro Ring Lite MR-14EX can use either of the following two external
power packs. For details on the power pack, refer to the Instructions of the
respective power pack.
(1) Compact Battery Pack CP-E2
Uses six size-AA alkaline, nickel-hydride, or lithium batteries.
(2) Transistor Pack E
Uses Battery Magazine TP (six size-C alkaline batteries) or Ni-Cd
Pack TP.
Recycling Time and Flash Count
(Applicable to both or only one flash tube tiring)
Power Source
Recycling
Flash Count
Time (sec.)
Internal Power
Size-AA alkaline batteries Approx.0.1-7 Approx.120-800
Sources
Compact Battery Pack CP-E2
Approx.0.1-4 Approx, 400-2500
External Power
(w/alkaline batteries)
Sources
Transistor Pack E (w/alkaline batteries) Approx.0.1-4 Approx. 400-2500
Transistor Pack E
(wiN
i-Cd Pack TP) Approx. 0.1-3 Approx. 330-2000
• The minimum recycling time applies in the E-TTL or TIL mode while the
maximum recycling time applies in the manual or full-output (1/1) mode.
• The minimum flash count applies in the manual or full-output (1/1) mode
while the maximum flash count applies in the E-TIL or TTL mode.
• The above specifications are based on Canon's testing standards .
. . -Evenwhen
an~xternal
power source is used, batteries must still be installed in
tbeMR-14EX to power its internal circuitry.
-TheMR-14EX uses both the internal and external power sources to recycle
the flash. Therefore,. the. internalpower source. maybecome exhausted sooner
thanthe
externalpow~rso~
rce.
ForproI5m~edflash·
photography,keep a spare
set of· size-AA batteries handy fortheinternal. power source.
12