NEC PA1004UL-B User Manual page 33

Terminal Panel Features
6 3
12
1. HDMI 1 IN Terminal (Type A)
(→ page 161, 163, 165)
2. HDMI 2 IN Terminal (Type A)
(→ page 161, 163, 165)
3. DisplayPort IN Terminal
(→ page 161)
4. COMPUTER IN/ Component Input Termi-
nal (Mini D-Sub 15 Pin)
(→ page 160, 164)
5. COMPUTER AUDIO IN Mini Jack (Stereo
Mini)
(→ page 160, 163)
6. HDBaseT IN/Ethernet Port (RJ-45)
(→ page 166, 167)
7. HDBaseT OUT/Ethernet Port (RJ-45)
(→ page 167)
8. AUDIO OUT Mini Jack (Stereo Mini)
(→ page 163, 165)
9. USB-A Port (Type A)
(→ page 48)
10. LAN Port (RJ-45)
(→ page 168)
11. 3D SYNC Terminal (Mini DIN 3 Pin)
(→ page 53)
1. Check the product overview, supplied items and part names
1 2
13 8
7
11
12. PC CONTROL Port (D-Sub 9 Pin)
(→ page 189)
Use this port to connect a PC or control
system. This enables you to control the pro-
jector using serial communication protocol.
If you are writing your own program, typical
PC control codes are on page 197.
13. REMOTE Terminal (Stereo Mini)
Use this terminal for wired remote control
of the projector.
(→ page 15)
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be
performed.
• When [HDBaseT] is selected in the [REMOTE SENSOR] and the
projector is connected to a commercially-available transmis-
sion device that supports HDBaseT, remote control operations
in infra-red cannot be carried out if transmission of remote
control signals has been set up in the transmission device.
However, remote control using infrared rays can be carried
out when the power supply of the transmission device is
switched off.
9
4 5 9
10