Table of Contents
Advertisement
Deciding on where to install the product
Drilling a hole in the wall
f Drill a hole of a 90mm in diameter at a less than 200mm in height from
X
the bottom of the indoor unit in a slightly downward slope.
Preparing the installation
Installing duct for horizontal exhaust discharge
It is necessary to install an air-discharge duct(field supply) to direct exhaust from the fan horizontally if it is difficult to provide
a minimum space of 2m between the air-discharge duct outlet and a nearby obstacle as shown in the figure.
Discharged air
Ex) Balcony
Installing the outdoor unit in harsh environments
In abnormally harsh environments such as windy areas, sufficient countermeasures to guard against excessive wind should
be taken to ensure the unit's correct operation.
❖ When installing ducts
• The frame/foundation shall be made of angle steel, etc., and
designed so that wind slip through the structure.
• Install unit so that wind will not directly lash against openings of
inlet and outlet ducts.
• The foundation must be solid and the unit must be secured
with anchor bolts.
CAUTION
• Be sure to install unit in a place strong enough to withstand
its weight. When installing on a roof subject to strong wind,
countermeasures must be taken to prevent the unit from
being overturned.
• Be sure to install unit in a place strong enough to withstand
its weight.
30
PAC_아프리카 중동향AP80S0A_IBIM_34514A-02_EN.indd 30
Upper floor
Suction air
Ex) Mechanical room
Indoor
Less than
200mm
Discharged air
Gill/Louver
782
2000
560
880
560
Outdoor
Ø 90mm
871
765
550
2015-04-23 오후 2:18:57
Advertisement
Table of Contents
