Step 6 – Adjust Load Stop to Fit Ladder ......................9 Before You Begin Read all instructions prior to assembling or installing any Kargo Master product. Always locate your installation locations prior to performing any work. ENSURE SAFETY WHILE INSTALLING ONTO VEHICLE.
Instructions – 4A823 DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF. Step 1 – Attach Load Plates Using a 5/16”-18 x 1” hex head bolt, 5/16” lock washer, and 5/16” flat washer, loosely bolt a slider plate to a load plate. The press nut on the slider plate face up.
Instructions – 4A823 Step 2 – Assemble Foot Assemblies Insert gutter clamp through the gutter foot rectangular slots as shown. LOOSELY bolt the gutter clamp to the gutter foot using a 5/16” x 1-1/4” carriage bolt, 5/16” flat washer, and 5/16”...
Instructions – 4A823 Step 3 – Attach Mounting Brackets Using a 5/16”-18 x 1” hex head bolt, 5/16” lock washer, and 5/16” flat washer, loosely bolt a mounting plate to a foot assembly. The press nuts on the mounting plate face up. DO NOT TIGHTEN.
Instructions – 4A823 Step 4 – Attach End Stops Using a 5/16”-18 x 1” hex head bolt, 5/16” lock washer, and 5/16” flat washer, loosely bolt a slider plate to an end stop. The press nuts on the slider plate face up. DO NOT TIGHTEN.
Instructions – 4A823 Step 5 – Install Rack to Vehicle Set crossbar assembly on vehicle. Be sure feet are inside rain channel on roof and clips are outside vehicles roof rain gutter. Center feet and rack to vehicle.
Instructions – 4A823 Step 6 – Adjust Load Stop to Fit Ladder Place ladder to be used in position, on rack, firmly against end stop. Slide load stop to fit ladder. Be sure to allow gap enough for ladder to be removed easily.