Ice Compartment; How To Make Ice - Hitachi R-Y6000J How To Use Manual

ICE COMPARTMENT

ICE COMPARTMENT ICE COMPARTMENT
Ice scoop
Be sure to put it straight.

How to Make Ice

Remove the water supply container.
Hold the handle and pull the container towards you.
Hold the body of the water supply
container and carry it carefully.
Push the water supply container fully into the "Container-
set position".
If the water supply container is not pushed properly into
place, the water won't be fill in and unable to make ice.
If the "Large ice cube making" light is not lit, press the
button to turn on the light.
Use the tap water. Water that has been chlorinated with apparatuses like filters, mineral water, and water
that has been boiled makes it easy for germs and bacteria to spread, therefore regular cleaning is required.
( Cleaning
When using mineral water, use the water with hardness of 100mg/L or less.
The bottom face of the water supply container may become warm due to anti-freeze heater installed.
28
R-Y6000J_R-Y5600J (E).indd 28
Large ice cube making / stop ice making switch
Water supply container
Perform "ice making cleaning" when you use the ice compartment for the first time.
Container-set position
Pg. 41)
100mg/L
Automatic ice maker
Pg. 29/29
Ice case
Fill with water.
Add water
line
Fill with water up to the "Container-full line".
Filling past this line will cause the water to leak
around the lid.
Push the water supply container fully
into the "Container-set position".
Ice is made
When not making ice
automatically.
Pg. 31/31
Notice
When using for the first time, ice making may
take more than 24 hours. It usually takes only
2 - 3 hours.
2 - 3
Pg. 40 / 40
Water supply
cover
Container-
full line
24
41
4/6/09 10:12:25 AM