Table of Contents
Advertisement
Care of the Automatic Ice Maker
In case of first using the ice maker or if more than a week has passed since the last use,
clean out any dust or smell in the ice trays or water channel.
Empty the ice case.
Press and hold the "Ice
making cleaning" button
on the internal control
panel for about 5 seconds
until it beeps.
5
Remove the towel
and any water or ice
collected in the case.
Care of the Water Supply Pipe
Remove the water supply container.
Water supply pipe
Water supply
container
There is a water supply pipe at
the inner side of the water supply
container.
Make sure to install the water supply pipe before attaching the water supply container because water may spill
inside the compartment if the water supply container is attached without the water supply pipe.
Do not disassemble the water supply pipe.
The surrounding of the water supply pipe may become warm due to anti-freeze heater installed in the bottom face
of the water supply container. It is not abnormal.
R-Y6000J_R-Y5600J (E).indd 41
Place a clean towel in
the bottom of the case.
Cleaning
Continue pressing
for 5 seconds
5
Wipe the case with
a dry towel.
Remove the water supply pipe.
The water supply pipe can be
removed by pulling down its top
towards you with a finger.
(Continue)
Cleaning the Ice Maker
Fill the water supply
container and set it in
its place.
After 3 minutes, the
alarm will stop and
cleaning is completed.
Close the door
and wait.
Once a year
Wash the water supply pipe with
water, and then reinstall it.
Frame
Fit the end of the pipe into the hole
and push the pipe towards the
inner side.
Close the freezer
doors (left and right).
Close!
3
41
4/6/09 10:12:35 AM
Advertisement
Table of Contents
