Hitachi R-Y6000J How To Use Manual page 12

PREPARATIONS
PREPARATIONS
A refrigerator is not something that "increases the freshness" of food. At best "a brake that some degree will slow down food going bad" is al
operation manual closely and take care to use your refrigerator correctly so you can keep foods at their best.
Installation location
The floor should be sturdy and flat.
In the following places, place a hard board of approximately
1cm thick under the refrigerator to cover the whole portion of
the bottom face.
Put some kind of sturdy boarding on the floor if the refrigerator leans
to one side, in the case of carpets that may change color from heat
exposure, or flooring and vinyl chloride floor cover. (The temperature
of the floor surface may reach 50-60°C in summer.)
The refrigerator could incline on a flexible and fragile floor.
A location away from direct sunlight and
heat is recommended.
This will reduce adverse effects to refrigerating power and keep
electricity costs down.
Direct sunlight will cause discoloration to the plastic parts of the
refrigerator.
A location is not damp and has good air
flow.
This will reduce rusting and help keep electricity costs down.
A minimum of 1cm on both sides and 5cm above.
The refrigerator releases heat in order to keep the food cold. For efficient cooling,
allow enough space around the refrigerator.
Dimension of the center part of the side of the main body is slightly larger than the
displayed dimension. Extra dimension should thus be allowed when installing the
refrigerator for better radiation efficiency.
The back of the refrigerator can be placed next to a wall; but if there is a vibrating
sound or the wall color blackens (this is caused by the air around the compressor),
then move the refrigerator away.
12
R-Y6000J_R-Y5600J (E).indd 12
50 60°C
It takes about 4 hours
to fully cool down after
the power is on.
Do not tear off the sticker
at the back.
It may result in inefficiency
of coldness.
Sticker
4/6/09 10:12:12 AM