BMW 2 COUPE Series Owner's Manual page 211

Lanes depend on the steering angle and are
continuously adjusted to the steering wheel
movements.
Turning circle lines
Turning circle lines can only be superimposed on
the camera image together with lanes.
Turning circle lines show the course of the small‐
est possible turning radius on a level road.
Only one turning circle line is displayed after the
steering wheel is turned past a certain angle.
Parking using lanes and turning circle lines
1. Position the vehicle so that the red turning
circle line leads to within the limits of the
parking space.
2. Turn the steering wheel to the point where
the green lane covers the corresponding
turning circle line.
Obstacle marking
Depending on the vehicle equipment, obstacles
behind the vehicle are detected by the PDC Park
Distance Control sensors.
Driver assistance systems
Online Edition for Part no. 01405A38726 - VI/21
Obstacle markings can be faded into the image
of the rearview camera.
The colored thresholds of the obstacle markings
match the markings of the PDC Park Distance
Control.
Setting brightness and contrast
With the rearview camera switched on:
1. Move the Controller to the right, if needed.
2. "Camera image"
3. Select the desired setting.
System limits
System limits of the sensors
Additional information:
▷ Cameras, refer to page 35.
Deactivated camera
When the camera is deactivated, for instance
when the trunk lid is open, the camera image is
displayed hatched in gray.
Detection of objects
Very low obstacles as well as high, protruding
objects such as ledges may not be detected by
the system.
Depending on the vehicle equipment, some as‐
sistance functions also consider data from the
PDC Park Distance Control.
Follow the notes in the PDC Park Distance Con‐
trol chapter.
The objects displayed on the Control Display
may be closer than they appear. Do not estimate
the distance from the objects on the display.
CONTROLS
211