Removing The Cooktop Parts - LG LDG4313BD Service Manual

WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
CAUTION
• The 2 lock tabs on each igniter
switch are fragile. Tab breakage can
occur if excessive release pressure
is applied.
• Check that the gas seal gasket on
the screw and the gas valve remain
in place before installing the new
gas valve.
NOTE: When servicing the burner housing or the
valve, it is necessary to service also the pipe which
is designated.
1. Turn off the electric supply and gas supply going
to the range.
2. Remove the manifold panel (See the page 3-5).
3. Remove the cooktop plate (See "REMOVING
THE COOKTOP PLATE" on page 3-5).
COMPONENT ACCESS

REMOVING THE COOKTOP PARTS

4. To remove the valve:
a) Remove the fitting that you need to remove.
b) Remove the ignition switch with rubber
packing by prying on the 2 release tabs and
slide the switch off the valve stem.
c) Remove the valve screw and remove the valve.
Screw Seal
Valve Screw
Valve Seal
Single Burner valve
3-6