LG LDG4313BD Service Manual page 60

Symptoms and Questions
Self Clean is not working.
"Crackling" or "popping" sound.
Too much smoke during the Self
Clean cycle.
The oven door does not open after a
Self Clean cycle.
The oven door is not clean after a
Self Clean cycle.
Clean and door flash in the display.
"Loc" message appears when you
want to cook.
Oven control beeps and displays an
Ferror code.
The oven racks were cleaned in a
Self Clean cycle.
Clock is flashing.
"Burning" or "oily" odor emitting from
the vent.
Strong odor.
TROUBLESHOOTING
• The oven temperature is too high to set a self clean operation. Allow the
range to cool down to room temperature and reset the controls.
• Improper oven control settings. See Self Clean in the MAINTENANCE
section.
This is the sound of the metal heating up and cooling down during both
the cooking and cleaning functions. This is normal.
Too much soil in the oven. Open the windows to get rid of the smoke from
the room. Touch the Upper Clear/Off or Lower Clear/Off key. Wait until the
light goes off before trying to open the oven door. Wipe up the excess soil
and reset the clean cycle.
The oven temperature is too high. Wait up to one hour for it to cool down
• Incorrect oven control settings. See Self Clean in the MAINTENANCE
section.
• The oven was heavily soiled. Clean up heavy spills before beginning the
Self Clean cycle. Heavily soiled ovens may need either a longer Self
Clean or two Self Clean cycles.
• The self clean cycle has been selected, but the door is not closed.
- Close the oven door.
The oven door is locked because the temperature inside of the oven is
too high.Touch the Upper Clear/Off or Lower Clear/Off key.
• Check the main gas shut-off
valve or the oven gas shut-off
valve and call for service.
• Remove the power from the
range for five minutes and then
reconnect the power. If the
function error code repeats,
call for service.
Apply a small amount of vegetable oil to a paper towel and wipe the
edges of the oven racks. Do not use lubricant sprays.
Power outage or surge. Reset the clock. If the oven was in use, you must
reset it by touching the Upper Clear/Off or Lower Clear/Off key. Reset the
clock and any cooking function.
This is normal in a new oven. To speed the process, set a Self Clean
cycle for a minimum of three hours. See Self Clean in the
MAINTENANCE section.
An odor from the insulation around the inside of the oven is normal for the
first few times the oven is used.
8-4
Possible Cause/Solution
CODE
F-3
F-9
F-19
CAUSE
Touch key error
Main oven heating error
(Upper oven)
Main oven heating error
(Lower oven)