tee will become invalid, if such accesso-
ries or parts have been used.
Never try to replace the parts and
♦
repair the unit by yourself. Contact an
authorized service center for qualified
examination and repair.
Do not use the appliance if the
♦
mains cord, the plug or other parts are
damaged.
If the mains cord of this appliance
♦
is damaged, it must always be replaced
by manufacture or a service center au-
thorized, in order to avoid hazardous
situations.
Thoroughly clean the parts that
♦
will come into contact with food before
you use the appliance for the first time.
Unplug the appliance immediately
♦
after use and before cleaning.
Use only the pusher to push ingre-
♦
dients down the feed tube while the
appliance is running.
Keep the appliance out of the
♦
reach of children.
Never let the appliance run unat-
♦
tended.
Switch the appliance off before
♦
detaching and install any accessory.
Wait
until
moving
♦
stopped running before you remove the
parts of the appliance.
Never immerse the motor unit in
♦
water or any other liquid. Use only a
moist cloth to clean the motor unit.
Do not attempt to grind bones,
♦
nuts or other hard items.
Continuous running of meat grind-
♦
er should be not more than 10 min.
Before it's used again, it must cool down
enough, about 10 min.
Reverse
function
♦
while the appliance is operating (For
example, switch "ON" knob to "R" knob
or on the contrary), wait at least one
minute until grinder has come to a
complete stop. Otherwise it may result
in damaging of the appliance.
To avoid jamming, do not apply
♦
excessive pressure while operating.
When the circuit breaker activates,
♦
do not switch on.
To protect against the risk of elec-
♦
trical shock, do not immerse the unit,
cord or plug in water or other liquid.
This appliance is not intended for
♦
use by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person re-
sponsible for their safety. Not recom-
mended for usage by children till the
age of 14.
parts
have
is
prohibited
4
Children should be supervised to
♦
ensure that they do not play with the
appliance.
Service life – 4 years.
♦
Before putting into operation shelf
♦
life is unlimited.
FOR THE FIRST TIME
Check that voltage indicated on
♦
the rating label corresponds the mains
voltage in your home.
Wash all parts (except body) in
♦
warm soapy water.
Before plugging in, ensure the
♦
"ON/OFF/ Reverse" switch is turned to
"OFF" position.
REVERSE FUNCTION
In case of jamming, switch the
♦
appliance off by turning the "R / ON"
switch to "R" position and "ON/OFF/
Reverse" switch to "R" position. Feed
screw will be rotating in the opposite
direction, and the head will get empty.
FOR USE ASSEMBLING
Make sure the unit is unplugged
♦
while assembling.
Insert the feed screw into the
♦
grinder tube, long end first (fig. 1).
Position the cutting blade onto the
♦
feed screw with the flat surface of the
blade facing you.
NOTE: If it is not fitted properly, meat
will not be ground the cutting plate may
be damaged (fig. 2).
Position the desired cutting plate
♦
onto the feed screw, against the flat
sides of the cutting blade. Be sure the
notched on the cutting plate fit into the
slots in the grinder tube (fig. 3).
Securely attach the cap to the end
♦
of the grinder tube (fig. 4). Do not over-
tighten.