12 Replace the controller's cover.
Wiring the VVT Bypass Controller for power
WARNING Do not apply line voltage (mains voltage) to the controller's ports and terminals.
CAUTIONS
•
The VVT Bypass Controller is powered by a Class 2 power source. Take appropriate isolation measures when
mounting it in a control panel where non-Class 2 circuits are present.
•
Carrier controllers can share a power supply as long as you:
•
Maintain the same polarity.
Use the power supply only for Carrier controllers.
○
To wire the controller for power
1
Remove power from the power supply.
2
Pull the screw terminal connector from the controller's power terminals labeled Gnd and 24 Vac or Hot.
3
Connect the transformer wires to the screw terminal connector.
VVT Bypass Controller
Installation and Start-up Guide
Tube installation
High
Low
Carrier Proprietary and Confidential
9
Installing the VVT Bypass Controller
CARRIER CORPORATION ©2017
All rights reserved