Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT SAFETY INSTRUCTION (cont.)
WARNING : Risk of damp. Silicone sealant shall be applied to connections of the drain pipe and the drainage
pipeline.
CAUTION : If the bath will be idle for a long term, make sure the water in pipeline is drained completely.
The residual water may freeze in winter or go bad in summer.
CAUTION: If you find the water supply pipe has been frozen, do not use the bath. You will need to raise
the room temperature and use it after the water is thawed.
CAUTION : Before use after long term idle condition, make sure to wash it for several times and the inner
pipelines are clean.
Use this whirlpool bath only for its intended purpose as described in this manual. Do not use attachments not
recommended by the manufacturer.
Never drop or insert any object into any opening.
Product Information
Factory installed components include whirlpool pump with power supply cord, drain, controller, piping, water
level sensor, user keypad, and keypad cable. Other than power wiring and plumbing, no assembly is needed.
Electrical Requirements
The installation must have two Class A Ground-Fault Circuit-Interrupters (GFCI's), Earth-Leakage Circuit-Breaker
(ELCB), or Residual Current Devices (RCD's). The GFCI's, ELCB's, or RCD's protect against line-to-ground shock
hazard. Use a 220-240 V, 20 A (minimum), 50/60 Hz dedicated service for the bath with airjets.
Plubing Requirements
The minimum inlet water pressure for the faucet diverter is 0.05Mpa (0.5 bar).
The whirlpool bath must be connected only to a supply circuit that is protected by a residual current device
(RCD). Such a RCD should be provide by the installer and should be tested on a routine basis. To test the RCD,
press test button. The RCD should interrupt power. Press the reset button. Power should be restored. If the RCD
fails to operate in this manner, the RCD is defective. If the RCD interrupts power to the bath without the test
button being pressed, a ground current is flowing, indicating the possibility of an electric shock. Do not use this
bath. Disconnect the bath and have the problem corrected by a qualified service representative before using.
WARNING : Unauthorized modification may cause unsafe operation or affect performance of the whirlpool.
Do not relocate the motor, or make other modifications to the system in the absence of kit instructions, as
this could adversely affect the performance and safe operation of the whirlpool. Kohler Co. shall not be
liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized
modification.
Tools
Silicone Sealant
Safety Glasses
Kohler Co.
Measuring Tape
Pipe Wrench
Pencil
Plus:
• Conventional woodworking or
concrete installation tools and materials
• Drop cloth
3
Level
1334405-EM2-A
Advertisement
Table of Contents
