Wired Remote Controller; 4-1.Display Section - Carrier XPower Owner's Manual

Sleep timer operation
To start the sleep timer (OFF timer) operation.
PRESET FAN
MODE
SWING FIX HI-POWER
CLR
1
SLEEP ON OFF
SET
CHK FILTER CLOCK
1
Press the SLEEP button.
Select 1, 3, 5 or 9 hours for the OFF timer
operation.
25-EN
1115350277.indd 14
– 13 –
4

Wired remote controller

This remote controller can control the operation of up to 8 indoor units.
4-1. Display section
In the display illustration below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When the leak breaker is turned on for the first time,
part of the remote controller.
• While this icon is flashing, the model is being automatically confirmed.
Wait till icon has disappeared to use the remote controller.
1
2
5
6
9
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or a error
occurs.
3
SETTING display
Displayed during setup of the timer or other settings.
4
TEST run display
Displayed during a test run.
5
Timer display
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
7
Louver position display
Displays louver position.
8
Swing display
Displayed during up / down movement of the louver.
flashes on the display
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
7 8
3 4
12
11
10
9
Filter display
Reminder to clean the air filter.
10
Fan speed display
The selected fan speed mode is displayed.
(Auto)
(High)
(Med.)
(Low)
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save energy.
Display
section
Operation
section
26-EN
9/27/2018 8:57:12 AM