Carrier XPower Owner's Manual page 12

Automatic operation
(auto changeover)
Start
3
PRESET FAN 4
1
MODE
2
1
START/STOP button ( )
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select A.
3
Temperature button ( )
Set the desired temperature.
4
Fan speed button (FAN)
+
Select one of LOW , LOW ,
+
MED , MED , HIGH
• The OPERATION lamp (green) on the signal
receiving unit lights.
The operating mode is selected in accordance with
the room temperature and operation starts after
approximately 3 minutes.
• If the "A" mode is uncomfortable, you can select the
desired conditions manually.
Stop
START/STOP button ( )
Press this button again to stop the air conditioner.
In the Cool, Dry, or Auto (cooling) mode, the fan runs
for 10 minutes (or more) for self clean operation.
21-EN
1115350277.indd 12
.
– 1 – 1
Timer operation
Use the wired remote controller for timer setting if it is
also in use.
ON timer and OFF timer
FAN
PRESET
MODE
1
SWING FIX HI-POWER
3
CLR
ON OFF 2
SLEEP SET
CHK FILTER CLOCK
Setting TIMER
1
Push ON / OFF TIMER button ( or ) during
ON
operation.
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and
flashes along with ON / OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the time
in ten minute steps.
Pressing the TIMER button continually changes
the time in one hour step.
2
SET button
Press the SET button to set the timer.
The timer time is indicated and the timer starts.
Cancelling TIMER
3
CLR button
Press the CLR button to cancel the timer
setting.
CAUTION
• When you select the timer operation, the remote
controller automatically transmits the timer signal to
the indoor unit at the specified time. Therefore, keep
the remote controller in a location where it can
transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will occur.
• If you do not press the SET button within 30
seconds after setting the time, the setting will be
cancelled.
Once you select the timer operation mode, the settings
are saved in the remote controller.
Thereafter, the air conditioner will start operating under
the same conditions when you simply press the ON /
OFF button of the remote controller.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section "Setting the clock"
and then set the timer.
Combined timer (Setting both ON
and OFF timers simultaneously)
OFF timer —> ON timer
(Operation —> Stop —> Operation)
OFF
This feature is useful when you want to stop the air
conditioner after you go to sleep, and start it again in
the morning when you wake up or you return home.
Example:
To stop the air conditioner and start it again next
morning.
Operation Operation again
Stop
Setting combined TIMER
1
Press the OFF TIMER button to adjust the
OFF
OFF timer.
2
Press the ON TIMER button to adjust the
ON
ON timer.
3
Press the SET button.
TH
2 -EN 2
9/27/2018 8:57:12 AM