3-4.Signal Receiving Unit; 3-5.How To Use Remote Controller - Carrier XPower Owner's Manual

4-way cassette air conditioner
Hide thumbs Also See for XPower:
Table of Contents

Advertisement

• When you select the timer operation, the remote
controller automatically transmits a signal to the
indoor unit at the specified time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of up
to 15 minutes may occur.
Remote controller holder
Installing the remote controller
holder
• Before you actually install the remote controller
holder on a wall or pillar, check whether the
remote controller signals can be received by the
indoor unit.
Mounting and removing
the remote
controller
• To mount the remote controller hold it parallel to
the remote controller holder and push it in fully.
To remove the remote controller slide the remote
controller upwards and out from the holder.
Flat head wood
screw
19-EN
1115350277.indd 11
3-4. Signal receiving unit
The signal receiving unit is attached to the indoor unit.
4
5
6
1
2
3
1
Temporary operation button
(See page 1 )
8
2
Signal receiving part
The signal sent from the remote controller is
received.
3
Display lamp
One of displays flashed while an error occurs.
When the display lamp flashes, refer to
"Troubleshooting".
4
lamp (Green)
This lamp illuminates when unit is on.
5
lamp (Green)
This lamp illuminates while the timer is reserved.
6
lamp (Orange)
This lamp flashes during self clean operation and
initial communication.
CAUTION
Disagreement in operation mode.
• If you use a wireless remote controller of another
Toshiba air-conditioner and attempt to operate a
function incompatible with this model, only a reception
sound is heard and the function is not performed.
(There is a case that the
and
lamps blink
alternately to inform you of the above.)
3-5. How to use remote controller
Cooling / fan only operation
Start
3
PRESET
FAN
4
1
MODE
2
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
, or Fan only
.
3
Temperature button (
)
Set the desired temperature.
When the air conditioner is in FAN ONLY
operation, the temperature display is not
indicated.
4
Fan speed button (FAN)
+
Select one of
LOW
, LOW
,
+
MED
, MED
, HIGH
• The
OPERATION lamp (green) on the signal
receiving unit goes on. And operation starts after
approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The
: Fan only mode does not control
temperature.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
In the Cool, Dry, or Auto (cooling) mode, the fan runs
for 10 minutes (or more) for self clean operation .
– 10 –
Dry operation
Start
3
PRESET
FAN
1
MODE
2
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY
.
3
Temperature button ( )
Set the desired temperature.
• The fan speed display indicates
• The
OPERATION lamp (green) on the signal
receiving unit lights, and operation starts after
approximately 3 minutes.
.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
In the Cool, Dry, or Auto (cooling) mode, the fan runs
for 10 minutes (or more) for self clean operation.
EN
EN
20-EN
9/27/2018 8:57:12 AM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents