3-2.Adjusting Clock; 3-3.Handling The Remote Controller - Carrier XPower Owner's Manual

Preparation and check before
use
Loading batteries
1
Remove the battery cover.
2
Insert 2 new batteries (R03 [AAA]) following
the (+) and (–) positions.
Batteries
• To replace the batteries, use two new batteries (R03
[AAA]).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep
from the indoor unit or when the air conditioner
cannot be operated using the remote controller.
• To avoid malfunctions by battery leakage, remove
the batteries when not using the remote controller for
more than one month.
17-EN
1115350277.indd 10
3-2. Adjusting clock
Setting the clock
Before you start operating the air conditioner, set the
clock of the remote controller using the procedures
given in this section. The clock panel on the remote
controller will indicate the time regardless of whether
the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller the
clock panel will indicate AM 0:00 and will flash.
PRESET FAN
MODE
SWING FIX HI-POWER
1
CLR
2
SLEEP ON OFF SET
CHK FILTER CLOCK
1
TIMER or button
ON OFF
Press the TIMER or button to set the current
ON OFF
2
SET button
Press the SET button.
The current time is indicated and the clock starts.
– 9 –
Clock adjusting
PRESET FAN
MODE
SWING FIX HI-POWER
2
CLR
SLEEP ON OFF SET 3
1
CHK FILTER CLOCK
1
CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display flashes.
2
TIMER or button
OFF
ON
Press the TIMER or button to set the current
ON OFF
time.
Each press of the TIMER button changes the time
by one minute.
Pressing the TIMER button continually changes
the time by ten minutes.
3
SET button
Press the SET button.
The current time is indicated and the clock starts.
3-3. Handling the remote
controller
CAUTION
• The air conditioner will not operate if curtains, doors or
other materials block the signals from the remote
controller to the indoor unit.
• Prevent any liquid from falling into the remote
controller.
• Do not expose the remote controller to direct sunlight
or heat.
• If the infrared signal receiver on the indoor unit is
exposed to direct sunlight, the air conditioner may not
function properly.
Use curtains to prevent the sunlight from reaching the
receiver.
• If the room using the air conditioner has fluorescent
lighting with electronic starters, signals may not be
properly received. If you are planning to use such
fluorescent lamps, consult your local dealer.
• If other electrical appliances react to the remote
controller move these appliances or consult your local
dealer.
Location of the remote
controller
• The standard distance for signal reception is
approximately 8 m vertically against the signal
receiving unit. The distance becomes shorter when
the angle is oblique against the signal receiving unit.
The distance differs a little according to the capacity
of the battery or other factor.
Signal receiving unit
Each press of the TIMER button changes the time
in one minute steps.
Pressing the TIMER button continually changes 90°
the time in ten minute steps.
8 m
2
SET button
Press the SET button.
The current time is indicated and the clock starts.
• Keep 1 m or more from the devices such as
television, stereo, etc.
(Disturbance of image or noise may generate.)
• To prevent a malfunction, select a place where is not
influenced by a fluorescent light or direct sunlight.
• Two or more (Up to 6 units) indoor units with wireless
type remote controller can be installed in the same
room.
9/27/2018 8:57:12 AM
TH
18-EN