3-3.Handling The Remote Controller; 3-4.Signal Receiving Unit - Carrier 40TSV0131UP Owner's Manual

Clock adjusting
2
ON OFF
3
1
1
CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display flashes.
2
TIMER or button
OFF
ON
Press the TIMER or button to set the current
ON OFF
time.
Each press of the TIMER button changes the time
by one minute.
Pressing the TIMER button continually changes
the time by ten minutes.
3
SET button
Press the SET button.
The current time is indicated and the clock starts.
13-EN
1115350208_EN-TH.indb 7 1115350208_EN-TH.indb 7
3-3. Handling the remote
controller
CAUTION
• The air conditioner will not operate if curtains, doors or
other materials block the signals from the remote
controller to the indoor unit.
• Prevent any liquid from falling into the remote
controller.
• Do not expose the remote controller to direct sunlight
or heat.
• If the infrared signal receiver on the indoor unit is
exposed to direct sunlight, the air conditioner may not
function properly.
Use curtains to prevent the sunlight from reaching the
receiver.
• If the room using the air conditioner has fluorescent
lighting with electronic starters, signals may not be
properly received. If you are planning to use such
fluorescent lamps, consult your local dealer.
• If other electrical appliances react to the remote
controller move these appliances or consult your local
dealer.
Location of the remote
controller
• The standard distance for signal reception is
approximately 8 m vertically against the signal
receiving unit. The distance becomes shorter when
the angle is oblique against the signal receiving unit.
The distance differs a little according to the capacity
of the battery or other factor.
Signal receiving unit
90°
8 m
• Keep 1 m or more from the devices such as
television, stereo, etc.
(Disturbance of image or noise may generate.)
• To prevent a malfunction, select a place where is not
influenced by a fluorescent light or direct sunlight.
• Two or more (Up to 6 units) indoor units with wireless
type remote controller can be installed in the same
room.
– 7 –
• When you select the timer operation, the remote
controller automatically transmits a signal to the
indoor unit at the specified time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of up
to 15 minutes may occur.
Mounting the remote
controller on the wall
Wall
Back of the remote
controller
Remote controller
mounting screw
When fixing the remote controller on the wall, insert the
supplied remote controller mounting screw into the wall
leaving a slight gap between the wall and the screw
head, and hang the remote controller by inserting the
screw head into the specified position on the back.
3-4. Signal receiving unit
The signal receiving unit is attached to the indoor unit.
4
5
6
1
2
3
1
Temporary operation button
(See page 15)
2
Signal receiving part
The signal sent from the remote controller is
received.
3
Display lamp
One of displays flashed while an error occurs.
When the display lamp flashes, refer to
"Troubleshooting".
4
lamp (Green)
This lamp illuminates when unit is on.
5
lamp (Green)
This lamp illuminates while the timer is reserved.
6
lamp (Orange)
This lamp flashes during self clean operation and
initial communication.
CAUTION
Disagreement in operation mode.
• If you use a wireless remote controller of another
Toshiba air-conditioner and attempt to operate a
function incompatible with this model, only a reception
sound is heard and the function is not performed.
(There is a case that the and lamps blink
alternately to inform you of the above.)
14-EN
3/29/2559 BE 6:54 PM 3/29/2559 BE 6:54 PM