Carrier WSHP Open v3 Integration Manual page 25

Use the Browse feature of the network management tool to verify that you can communicate and get real-
6
time values from the controller before connecting the BAS.
Once you have confirmed communications with the controller using the network management tool, connect
7
the BAS.
Verify that the BAS is connected properly to the LonWorks Option Card's 2-wire TP/FT-10 Net port, which is
8
polarity insensitive. The BAS may have to configure jumper or DIP switches on their end to support TP/FT-10.
WSHP Open v3
Integration Guide
21
Communications wiring
CARRIER CORPORATION ©2021
All rights reserved