Table of Contents
Advertisement
H7CX (Tachometer Function)
Settings for Advanced Functions
Note:
When using as a tachometer, switch to the tachometer configuration using the procedure given on page 31.
Settings that cannot be performed with the DIP switch are performed with the operation keys.
Power ON
(See note 2.)
(See note 1.)
3 s min.
3 s min.
Tachometer
output
mode
Counting
speed
Decimal
point
position
Prescale
value
Average
processing
Auto-zero
time
Startup
time
NPN/PNP
input mode
Display
color
Output
allocation
Key protect
level
26
Note:
1. If the mode is switched to the function setting mode during operation, operation will
2. Changes made to settings in function setting mode are enabled for the first time when
For details on operations in run mode, refer to page 29.
The characters displayed in reverse video are the initial values.
When performing settings with operation keys only, set pin1 of the DIP switch to OFF (factory setting).
If pin 1 of the DIP switch is set to ON, the setting items indicated by
Set each setting item using the
keys.
(HI-LO)
(AREA)
(HI-HI)
(30Hz)
(10kHz)
(One digit
(No decimal
after decimal
point)
point)
∼
∼
(0.001)
(1.000)
(99.999)
(Average
(Average of
(No aver-
of 2 mea-
4 measure-
age pro-
sure-
ments)
cessing)
ments)
∼
(0.1s)
(99.9s)
∼
(0.0s)
(99.9s)
(PNP
(NPN
input)
input)
(Red) (Green) (Red-green) (Green-red)
Note: Displayed for H7CX-AU@ models only.
(KP-1)
(KP-2)
(KP-3)
H7CX (Tachometer Function)
continue.
the mode is changed to run mode. Also, when settings are changed, the counter is re-
set (measured values initialized and output turned OFF) on returning to run mode.
will not be displayed.
(LO-LO)
(Two digits
(Three digits
after decimal
after decimal
point)
point)
(Average of
8 measure-
ments)
(KP-4)
(KP-5)
Hide quick links:
Advertisement
Table of Contents
