Page 1
Solid-state Counter H7CN All Required Counter Functions Incorporated in a Compact DIN-sized (48 x 48) Housing In addition to Up and Down models, a reversible (Up-Down) counter is also available Maximum counting speed of 5,000 cps, never before attained by a small-size preset counter Power supply freely selectable within a range of 100 to 240 VAC.
H7CN H7CN Specifications Ratings Supply voltage 24, 100 to 240 VAC 50/60 Hz 12 to 48 VDC (contains 20% ripple max.) (see note 1) Operating voltage range 85% to 110% of rated voltage Power consumption Approx. 12 VA/2.5 W (at 240 VAC, 50Hz) (see note 2) Approx.
H7CN H7CN Engineering Data Electrical Life Expectancy (Resistive load) (Inductive load) Load current (A) Load current (A) Operation Timing Charts Preset Counter Up Type Down Type Reset Reset Preset Preset Digital Digital display display Count-up Count-up Control Control output output...
Page 4
H7CN H7CN Totalizing Counter Up Type Reset *Full scale Digital display * Full scale: 9999 Input Mode Up/Down Selectable Type Note: (A) must be more than the minimum signal width. If (A) is set shorter than the minimum signal width, the error of count 1 may occur.
Page 5
Flush Mounting P3G-08 Y92F-30 Flush Back Panel Mounting Adapter Connecting Socket Y92F-30 P3G-08 H7CN H7CN + Adapter 103.7 95.1 P2CF-08 Panel Cutout H7CN- The standard panel cutout is as shown below. (Panel cutout con- forms to DIN43700.) Front Mounting Flush Mounting...
H7CN H7CN Protective Cover Backup Battery for Memory Protection The Protective Cover shields the front panel, particularly the count Y92S-20 value setting section from dust, dirt and water, and prevent malfunc- tioning of the Counter due to static electricity. Red lead wire (0.18 x 12 condu...
H7CN H7CN Input Connection The CP1 and CP2 reset inputs of the H7CN will be active when input to the H7CN is short-circuited. Solid-state Input (NPN) Contact Input Sensor (30 V max.) Sensor CP1 (N) CP1 (N) CP2 (N) (Reset)
Page 8
Counter, use the Y92A-48B Protective Cover, which is sold separately. Set each value to 0 and reset or turn the H7CN OFF and ON. Then the control output will be obtained instantly and can be used to test the system, unless the model is one other than the H7CN-M with a backup function.