Paradyne 9120 User Manual page 28

Displaying System Information
4-4
Health and Status Messages:
These messages appear in the left-most column of the System and Test Status
screen, or the highest priority Health and Status message appears on the last line
at the bottom of the screen (right-most corner).
Message What It Indicates
AIS at Network An Alarm Indication Signal
(AIS) is received by the
network interface. AIS is an
unframed, all ones signal.
1. Upstream access unit is
2. The network is
AIS at DSX-1 An Alarm Indication Signal
(AIS) is received by the
DSX-1 interface. AIS is an
unframed, all ones signal.
Backup Active Backup has been
established and data is
flowing over the alternate
DLCI.
BRI-B n Call Profile ISDN backup call (manual
Disabled or automatic) could not be
made because the Call
Profile had been disabled.
BRI-B n Call Profile ISDN backup call (manual
Invalid or automatic) could not be
made because the Call
Profile is invalid.
BRI-B n Call ISDN backup call (manual
Terminated by or automatic) was not
Remote End successful because it was
terminated at the remote
end.
Configuration Shortcut Configuration Shortcuts
Active feature is active, which
allows automatic
configuration and
cross-connection of DLCIs
as they are activated by the
network.
CTS down to Port - n The Port n CTS control
Device lead on the access unit is
off.
June 1997
transmitting AIS
(keep-alive signal).
transmitting an AIS.
What To Do
1. Check status of upstream
access unit(s).
2. Report problem to carrier.
Check the DTE attached to the
DSX-1 interface.
No action needed.
Enable the ISDN Call Profile
( Main Menu Control
ISDN Call Profiles Enable )
1. Verify that the ISDN Call
Profile identifier is not blank.
2. Check that the phone number
associated with the ISDN Call
Profile is valid.
1. Check configuration of the
remote device.
2. Verify that the remote device
is configured answer calls.
3. Verify Calling IDs.
No action needed unless you
want to disable this feature,
selected from the Main Menu.
1. Verify that the port is enabled.
2. Check DTR from Port-1 or
Port-2.
9121-A2-GB20-00