Advertisement
Quick Links
Value IP Series Network Camera
2MP, H265, IR & WDR
Quick Installation Guide
EBN1240-S
EHN1250-S
Copyright © EverFocus Electronics Corp.
Release Date: March, 2020
All the images including product pictures or screen shots in this document are for example only.
The images may vary depending on the product and software version. Information contained in
this document is subject to change without notice.
EverFocus Taiwan:
2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan
TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw
Advertisement
Related Manuals for EverFocus 2MP
Summary of Contents for EverFocus 2MP
- Page 1 The images may vary depending on the product and software version. Information contained in this document is subject to change without notice. EverFocus Taiwan: 2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw...
-
Page 2: Physical Description
1. Physical Description EHN1250-S SD Card Slot on EHN1250-S EBN1240-S No. Item Name Descriptions Light Sensor Detects lights. IR LEDs for infrared illumination in night vision IR LEDs applications. Lens Camera lens. Micro SD Card Slot Insert a micro SD card. Dimensions EHN1250-S EBN1240-S... - Page 3 2. Contact the shipper if any items appear to have been damaged in the shipping process. Optional Accessory You can go to the product page on EverFocus’ website to check the related optional accessories. www.everfocus.com.tw 2. Cables The cables provide connections for network, power, audio input / output and alarm input / output.
-
Page 4: Installation
EHN1250-S Reset Button Alarm Input / Output Audio Input Audio Output LAN / PoE Cable 12VDC Power Input EZN1240-S LAN / PoE Cable Power Cable (12VDC) Alarm IO PIN Assignment Alarm In Alarm Out Reset Button The Reset Button can be used to restore the camera to factory default. When the camera is powered up, press the Reset Button about 8 seconds to reboot the camera. - Page 5 Screw Position x 4 Optionally drill the 2 Cable Holes if you want to run the cables through the surface. 2. Remove the camera cover by unscrewing the 3 cover screws using the supplied Torx Wrench (Left Image). Screw the camera base to the surface using the supplied 4 Screws (Right Image).
- Page 6 b. Connect the RJ-45 cable to the LAN/PoE Cable of the camera. RJ-45 Cable LAN/PoE Cable c. Tightly screw the Cable Gland and Screw Cap to the Rugged RJ-45 Connector Cable. Screw Cap Cable Gland d. Crimp the RJ-45 connector onto the RJ-45 network cable. Note that the wires should be placed into the RJ-45 connector based on the following order (from left to right).
- Page 7 Anchors into the holes. Optionally drill a Cable Hole on the center if you want to run the cables through the surface. Screw Position x 3 Optionally drill a Cable Hole if you want to run the cables through the surface. 2.
- Page 8 6. Connect the camera to the network using the supplied Cable Gland Kit. Please refer to 3.1.6 7. Connect the camera to power. You can either connect the camera to a 12VDC power source or to a PoE switch using the PoE cable. 8.