Advertisement
6. Connect the camera to the network using the supplied Cable Gland Kit. Please
refer to 3.1.6
7. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
8. Access the camera live view. See 4. Accessing the Camera.
9. Adjust camera angles and then tightly twist back the Outer Housing.
4. Accessing the Camera
You can look up the IP address of the IP camera using the IP Utility (IPU)
program, which is included in the software CD.
The default IP mode of the IP camera is DHCP. However, if there is no dynamic IP
address assigned to the device, its IP will switch to 192.168.0.10
By default, the ID is admin and there is no password. Please input a password for
the first-time login.
EZN1240-A
5. Important Note for Motorized Lens Models
For motorized lens models (EHN1250-S), if you find the live
image out of focus, please try the instructions below:
1. Go to the Live page and open the Lens Control panel
(see image on the right).
2. Click the Restore button for the lens to restore to the
default position, and then click the Auto Focus button.
3. If the image is still out of focus, adjust the focus by
clicking the Focus "+" or "-" buttons.
EZN1240-A
7
P/N: 4605H125002001A
Advertisement
