Advertisement
+
+
+
2. Remove the camera cover by unscrewing the 3 cover screws using the
supplied Torx Wrench (Left Image). Screw the camera base to the surface
using the supplied 4 Screws (Right Image).
3. Optionally insert a micro SD card into the card slot (please refer to 1. Physical
Description).
4. Adjust the pan / tilt / rotate angles of the camera.
5. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
6. Connect the camera to the network using the supplied Cable Gland Kit.
a. Insert a RJ-45 network cable (without the RJ-45 connector on the one end)
through the supplied Waterproof Ring, Cable Gland, Stopper and Screw
Cap accordingly.
Waterproof Ring
Screw Position x 4
+
Optionally drill the 2 Cable Holes if
+
you want to run the cables through
+
the surface.
Cable Gland
Stopper
Screw Cap
4
Advertisement
