Checking The Binary Input/Output Circuits; Binary Input Circuits; Binary Output Circuits; Checking Optical Connections - ABB Relion 670 Series Commissioning Manual

Section 4
Starting up
1. Verify that the contacts are of current circuit type.
2. Verify that the short circuit jumpers are located in the correct slots.
Voltage circuit
1. Verify that the contacts are of voltage circuit type.
2. Check that no short circuit jumpers are located in the slots dedicated for voltage.
Trip and alarm circuits
1. Check that the correct types of contacts are used.
4.10

Checking the binary input/output circuits

4.10.1

Binary input circuits

Preferably, disconnect the binary input connector from the binary input cards. Check all connected
signals so that both input level and polarity are in accordance with the IED specifications.
4.10.2

Binary output circuits

Preferably, disconnect the binary output connector from the binary output cards. Check all connected
signals so that both load and polarity are in accordance with IED specifications.
4.11

Checking optical connections

Check that the Tx and Rx optical connections are correct.
48
Do not insert anything else to the female connector but the corresponding male
connector. Inserting anything else (such as a measurement probe) may damage the
female connector and prevent a proper electrical contact between the printed circuit
board and the external wiring connected to the screw terminal block.
An IED equipped with optical connections has an minimum space requirement of 180
mm (7.2 inches) for plastic fiber cables and 275 mm (10.9 inches) for glass fiber cables.
Check the allowed minimum bending radius from the optical cable manufacturer.
© 2017 - 2021 Hitachi Power Grids. All rights reserved
1MRK 511 403-UUS Rev. K
M11722-2 v4
M11722-4 v3
M11722-8 v3
M16022-2 v8
Bay control REC670
Commissioning manual