Completing The Test; Directional Underpower Protection Guppdup (37); Verifying The Settings - ABB Relion 670 Series Commissioning Manual

1MRK 511 403-UUS Rev. K
NO TRIP signal should appear.
11.4.12.2

Completing the test

Continue to test another function or end the test by changing the TESTMODE setting to Disabled.
Restore connections and settings to the original values, if changed for testing purposes.
11.4.13

Directional underpower protection GUPPDUP (37)

Prepare the IED for verification of settings as outlined in section
for test" in this chapter.
11.4.13.1

Verifying the settings

The underpower protection shall be set to values according to the real set values to be used.
The test is made by means of injection of voltage and current where the amplitude of both current and
voltage and the phase angle between the voltage and current can be controlled. During the test, the
analog outputs of active and reactive power shall be monitored.
1. Connect the test set for injection of voltage and current corresponding to the mode to be used in
the application. If a three-phase test set is available this could be used for all the modes. If a single-
phase current/voltage test set is available the test set should be connected to a selected input for
one-phase current and voltage.
Table 21:
Set value: Mode
A, B, C
Arone
PosSeq
AB
Table continues on next page
Bay control REC670
Commissioning manual
Calculation modes
Formula used for complex power calculation
=
S V
A
EQUATION2055 V1 EN-US
=
S V
AB
EQUATION2056-ANSI V1 EN-US
= ×
S 3 V
EQUATION2057-ANSI V1 EN-US
=
S V
AB
EQUATION2058-ANSI V1 EN-US
© 2017 - 2021 Hitachi Power Grids. All rights reserved
"Requirements"
* *
× + × + ×
I V I V I
A B B C C
* *
× - ×
I V I
A BC C
*
×
I
PosSeq PosSeq
* *
× -
( I I )
A B
Testing functionality by secondary injection
and section
*
Section 11
SEMOD55625-106 v4
SEMOD175027-3 v5
"Preparing
SEMOD175027-7 v7
(Equation 4)
(Equation 5)
(Equation 6)
(Equation 7)
113