Extreme Networks ExtremeSwitching Virtual Services Platform 4450GTX-HT-PWR+ Installation Manual page 35

Table 16: RJ45 Port LED state indicators
Label Color and Status
Speed/PoE+ Green, Blink
Green, Steady
Amber, Blink
Amber, Steady
Amber, Green Pulse
Off
Link / Activity Green, Steady
Green, Blink
Green, Slow Blink
Off
Table 17: SFP/SFP+ transceiver Port LED state indicators
Label Color and Status
In Use Green, Blink
Green, Steady
Amber, Blink
Amber, Steady
Off
Link / Activity Green, Blink
Green, Slow Blink
Green, Steady
Off
Note:
• If you connect two ports explicitly set for different speeds (for example one configured as
10BASE-T and the other as 100BASE-TX) the port link LED may indicate a link, but the
switch does not establish a link. Connect ports using the same set speed or use auto-
negotiation on each switch.
• The port Link/Activity LEDs graphically represented in EDM are always steady once a link
is established. They do not blink to reflect port traffic activity.
August 2018
Description
The port is set to operate at 1000 Mbps with PoE.
The port is set to operate at 1000 Mbps without PoE+.
The port is set to operate at 100 Mbps with PoE+.
The port is set to operate at 100 Mbps without PoE+.
The port is experiencing a PoE+ error.
When the Link/Activity LED is green and the Speed LED is off,
the port is set to operate at 10 Mbps for all models.
The link established but no data activity exists.
The link is established and data activity exists (the blink rate
indicates the level of activity).
The port is administratively disabled.
Local/remote fault.
Description
Not applicable.
The SFP/SFP+ port and the transmit port are active.
Not applicable.
SFP/SFP+ Installed—TX Port Inactive
No SFP/SFP+ transceiver is present.
Activity exists on the port.
Software disabled this port.
The link is operating normally.
No link exists.
Installing the Virtual Services Platform 4450GTX-HT-PWR+
LED state definitions
35