Msam/Usd Cards; Installing Or Changing Msam/Usd Card - VeriFone P400 Installation Manual

S
ETUP

MSAM/uSD Cards

WARNING
MSAM/uSD
Cards
CAUTION
Installing or
Changing MSAM/
uSD Card
NOTE
NOTE
14
P400/P400 P I
LUS NSTALLATION
3
Remove the clear protective film from the display.
4
Replace all the packing materials, close the lid, and save the carton for
repacking or moving the P400 unit in the future.
Do not use a unit that has been tampered with or otherwise damaged. This unit
comes equipped with tamper-evident label. If a label or component appears
damaged, immediately notify the shipping company and your Verifone
representative or service provider.
You may need to install one or more multiple security access module (MSAM)
cards or replace the old cards.
Figure 3 MSAM/uSD Slots
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. Verifone recommends using
a grounded anti-static wrist strap.
To install or change uSD or MSAM cardS:
1
Place the terminal face down on a soft and clean surface to protect the lens
from scratches.
2
Slide out and lift the compartment cover. The uSD and MSAM cardholders are
now accessible.
The P400 supports two MSAM cards in a stacked configuration.
3
Install the uSD or MSAM card by carefully sliding it into the slot until fully
inserted.
Insert the card with the card's gold contacts facing away from you, toward the unit.
G
UIDE