Stylus And Holder; Mounting Plate - VeriFone P400 Installation Manual

S
ETUP
Optional Accessories
Installing the Privacy
Shield

Stylus and Holder

Attaching the Stylus
Holder

Mounting Plate

Attaching a Mounting
Plate to P400
Mounting P400 with
Mounting Plate to a
Wall or Flat Surface
Mounting P400 to a
Flat Surface (Without
a Mounting Plate)
NOTE
26
P400/P400 P I
LUS NSTALLATION
To install a privacy shield:
1
Align the hooks on the privacy shield with the corresponding slots beside the
keypad on the terminal.
2
Once the hooks are in place, gently push down on the privacy shield until it
snaps into place.
A stylus with holder can be attached to P400 and used as an alternative device
input method.
To attach the stylus:
1
Align the stylus holder's screw holes with those found on the back of
the terminal.
2
Screw the holder onto the back of the terminal.
This accessory is used to mount P400 to vertical or inclined surfaces.
To attach a mounting plate to P400:
1
Align the screw holes at the back of the terminal with the corresponding
screws on the mounting plate (this can be done with or without the stylus
holder attached).
2
Screw the mounting plate in place, keeping the terminal aligned.
To mount the terminal to a wall or flat surface:
1
Ensure the mounting plate is attached to the terminal.
2
Attach three M3 screws (not included in P400 package) to the desired surface.
Make sure that they are aligned with the slots on top and at the bottom of the
mounting plate.
3
Secure the terminal with the mounting plate in place by aligning the holes to
the M3 screws then sliding the entire assembly into place.
4
Slide the terminal down to secure it to the mounting plate. To remove the
terminal, slide the terminal up and pull away from the mounting plate.
To mount the terminal to a flat surface:
1
Align the terminal's footers to the holes on the mounting plate.
2
Fit the footers of the terminal into the footer holes.
3
Screw the mounting plate in place.
Customized plates must have four recessed areas big enough to fit the footers of
the terminal. This ensures that there is no gap between the terminal and
mounting plate.
G
UIDE