PREPARING FOR USE
Before connecting your compressor
to the mains supply, check the
following:-
• Firstly, ensure the compressor is
on level ground. Do not allow it
to run if it is standing on an
incline.
• Check also that the mains
voltage corresponds with that
shown on the data label on the
side of the compressor.
• The ON/OFF switch is in the OFF position.
ADDING OIL
The compressor is supplied without
any oil inside.
1. Make sure that the oil level is half
way up the oil sight glass.
2. If not, remove the oil cap and top
up the reservoir.
• Only use Clarke synthetic
compressor oil, available from
your Clarke dealer (Part No.
3050795).
7