Preparing For Use; Adding Oil - Clarke SHHHAIR 50/9 Operation & Maintenance Instructions Manual

PREPARING FOR USE

Before connecting your compressor to the mains supply, check the following:-
• Firstly, ensure the compressor is on level ground. Do not allow it to run if
it is standing on an incline.
• Check also that the mains voltage corresponds with that shown on
the data label on the side of the compressor.
• The ON/OFF switch is in the OFF
position.
• Remove any transit caps from
the air inlets and replace them
with the air inlet filters supplied.

ADDING OIL

The compressor is supplied without any
oil inside.
1. Make sure that the oil level is half
way up the oil sight glass
2. If not, remove the oil cap and top
up the reservoir
• Only use Clarke synthetic
compressor oil, available from
your Clarke dealer (Part No.
3050795).
5