Table of Contents
Advertisement
PREPARING FOR USE
CONNECTING THE WHEELS & RUBBER FOOT
1. Unscrew the nut and two washers from the wheel axle.
2. Pass the wheel axle through the
axle hole in the wheel support
frame, as shown, with a washer
either side of the hole.
3. Replace and tighten the nut onto
the axle.
NOTE: Make sure that the nut is not
too tight, so the wheel has
free movement.
1. Unscrew the nut and washers from
the rubber foot.
2. Place the rubber foot bolt through
the foot support mount on the
underside of the air tank, as
shown.
3. Replace the washer and nut onto
the bolt and tighten.
FITTING THE AIR FILTERS
1. Remove the transit plugs from the air filter inlets.
2. Screw the air filters into the inlets,
as shown
9
Advertisement
Table of Contents
