Table of Contents
Advertisement
PREPARING FOR USE
Before connecting your compressor to the mains supply, check the following:-
• The mains voltage is 230V.
• The ON/OFF switch is in the OFF (lower) position.
• The pressure regulator should be set at its lowest setting, i.e. turned fully
anticlockwise.
• If the compressor has not been used for 24 hours or more, open the drain
valve to drain any condensate which may have accumulated. When
clear, close the valve, finger tight.
IMPORTANT: If the receiver is under pressure, keep your hands well away
from the air being expelled.... remember, compressed air is DANGEROUS!
Before connecting any airtool, make sure you have read and fully
understood the manufacturers instruction booklet for the tool being used.
Also ensure that the tool is compatible with the compressor and hose
If the pressure rating of the tool is less than 8 bar, the pressure regulator must
1
Attach the air hose to the air outlet tap
using the hose nut. See figure 5.
• Ensure that the drain valve is finger
tight.
2
Finally, plug the mains cable into the
supply socket and switch on the power.
WARNING!
specifications.
be used to adjust the output pressure.
Figure 5
Figure 6
12
Hose nut
On/Off Switch
Advertisement
Table of Contents
